4T: Difference between revisions

From National Optronics resources center
Jump to navigationJump to search
Line 18: Line 18:
== Technical information ==
== Technical information ==


* [http://nationaloptronics.net/download/4T/procedure/4T--Replacement-of-Memory-Chips.pdf Replacement of Software Chips for Software Update - 1st style 4T/4Ti main board]
* [http://www.nationaloptronics.net/download/4T/procedure/4T--Replacement-of-Memory-Chips.pdf Replacement of Software Chips for Software Update - 1st style 4T/4Ti main board]
* [http://nationaloptronics.net/download/4T/procedure/4T-Troubleshooting-Guide.pdf 4T Troubleshooting Guide]
* [http://www.nationaloptronics.net/download/4T/procedure/4T-Troubleshooting-Guide.pdf 4T Troubleshooting Guide]
 
* [http://nationaloptronics.net/download/4T/procedure/11190669InstallationofNewControllerBoardinOld4TProcedure.pdf  Procedure: Installation of New Controller Board in Old 4T]


* [http://www.nationaloptronics.net/download/4T/procedure/11190669InstallationofNewControllerBoardinOld4TProcedure.pdf  Procedure: Installation of New Controller Board in Old 4T]


=4Ti / 4TX / ES-Versa Software=
=4Ti / 4TX / ES-Versa Software=

Revision as of 14:45, 28 August 2015

Documentation

Manuals

4T


4TX / ES-Trace

Technical information

4Ti / 4TX / ES-Versa Software

Version 2.01

New features
  • Support the cycle burn-in function.
  • Arc-net largely disabled. Most functions immediately return or are commented out.
  • Implementation of servo test function for R. Wesner
  • Frame trace burn-in with statistics is provided and the compile switch governing whether frame bevel calibration is 1-eye or 2-eye is set to 2-eye.
  • Improved algorithm for std deviation during burn-in
Bugs fixed
  • (none)
Regression
  • Remove RESET soft-key on servo test screen. (Servo test not generally enabled.)
Download (WARNING - 4Ti product only!!!)

Version 2.00

New features
  • Driver for new Xilinx controller
  • Driver for new memory chips
Bugs fixed
  • (none)
Download (WARNING - 4Ti product only!!!)

4T Software

Version 1.35

New features
  • The DCS parameters FCRV and BEVC are both transmitted with job data (with the same value). Some hosts and edgers tend to use FCRV while other devices use BEVC.
  • The capability to update the code via the serial port is supported. See note #2 in “Other” below.
  • A and B offsets may now be specified for frames, patterns/rimless lenses, and beveled lenses. Total range of available offsets is now A, B, CIRC, and DBL.
  • Default values for the left/right carriage servo gains now match the defaults on the tuning sheet.
Bugs fixed
  • The C3/C2 correction to A and B size was applied to all frames, even those that are not high-wrap.
  • The FCRV was not computed independantly of the frame faceform wrap.
Download (WARNING - 4T product only!!!)