4T: Difference between revisions

From National Optronics resources center
Jump to navigationJump to search
Line 19: Line 19:


* [http://nationaloptronics.net/download/4T/manual/4Ti-Italian-Manual-Insert-Rev1.02.pdf Manuale Operatore Del Lettore 4Ti]
* [http://nationaloptronics.net/download/4T/manual/4Ti-Italian-Manual-Insert-Rev1.02.pdf Manuale Operatore Del Lettore 4Ti]
* [http://nationaloptronics.net/download/4T/manual/4Ti-Portuguese-Manual-Insert-Rev1.02.pdf Manual do Usuário do 4Ti]


== Technical information ==
== Technical information ==

Revision as of 14:25, 30 January 2012

Documentation

Manuals

4T
4Ti

Technical information

  • Sorry no procedures are available

4T Software

Version 1.35

New features
  • The DCS parameters FCRV and BEVC are both transmitted with job data (with the same value). Some hosts and edgers tend to use FCRV while other devices use BEVC.
  • The capability to update the code via the serial port is supported. See note #2 in “Other” below.
  • A and B offsets may now be specified for frames, patterns/rimless lenses, and beveled lenses. Total range of available offsets is now A, B, CIRC, and DBL.
  • Default values for the left/right carriage servo gains now match the defaults on the tuning sheet.
Bugs fixed
  • The C3/C2 correction to A and B size was applied to all frames, even those that are not high-wrap.
  • The FCRV was not computed independantly of the frame faceform wrap.
Download (WARNING - 4T product only!!!)

4Ti Software

Version 2.00

New features
  • Driver for new Xilinx controller
  • Driver for new memory chips
Bugs fixed
  • (none)
Download (WARNING - 4Ti product only!!!)